Wurth Master EWS 7-115 Notice D'utilisation page 16

EWS 115..book Seite 16 Dienstag, 15. Mai 2007 11:18 11
Flap Disc
With the flap disc (accessory), curved surfaces and
profiles (contour sanding) can be worked.
Flap discs have a considerably higher service life
than sanding sheets, lower noise level and lower
sanding temperatures.
Cutting
When cutting, do not press, tilt or
oscillate the machine. Work with
moderate feed, adapted to the mate-
rial being cut.
Do not reduce the speed of running down cutting
discs by applying sideward pressure.
Maintenance and Cleaning
Disconnect the mains plug from electric supply.
For safe and proper working, always keep the
machine and its ventilation slots clean.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be
degraded. The use of a stationary extraction
system is recommended in such cases as well
as frequently blowing out the ventilation slots
and installing a residual current device (RCD).
If the machine should fail despite the care taken in
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
For all correspondence and spare parts orders,
always include the article number on the type plate
of the machine.
For the current spare parts list of this machine, log
into the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest
Würth branch office.
16
Power tools, accessories and packaging should be
disposed of for recycling in an environmentally
friendly manner.
and electronic equipment and its implementation
into national law, power tools that are no longer
usable must be collected separately and recycled in
an environmentally friendly manner.
Würth will gladly take back your defective Würth
The direction in which
power tool free of charge.
the cutting is per-
formed is important.
The machine must
always work in an
For this Würth tool, we provide a warranty in
up-grinding motion.
accordance with statutory /country-specific regula-
Therefore, never move
tions from the date of purchase (proof of purchase
the machine in the other
by invoice or delivery note). Damage that has
direction! Otherwise,
occurred will be corrected by replacement or repair.
the danger exists of it
Damage caused by normal wear, overloading or
being pushed uncon-
improper handling is excluded from the warranty.
trolled out of the cut.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee
Disposal
Only for EU countries
Do not dispose of power tools into
household waste!
According to the European Guide
Lines 2002/96/EC for waste electric
Warranty