ARDES AR076 Mode D'emploi page 9

IMPORTANT NOTE: the perception of heat varies from person to
person. If the temperature is too high for you after the charge period, do
not use the appliance and allow it to cool; for successive use, lower the
charging temperature by disconnecting the power cable from the socket
before the LED turns off: the shorter the charging time, the lower the
temperature.
With a full charge cycle, if used covered (for example in bed) with its
casing, the device remains heated for approximately 6 hours; if left
uncovered at room temperature, the device remains heated for about 4
hours.
Disconnect the plug from the socket and let the appliance cool down
well before cleaning it.
Frequently examine the appliance to make sure there are no signs of wear
or deterioration.
If there are such signs or if the appliance has been used improperly, bring it to
an authorized service center before using it.
This appliance does not require any special maintenance.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from
entering into the appliance and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Clean the bag following the indications given on the special label applied to
the inner part of the appliance.
Maintenance
GB
9