REMA DSD05 Série Mode D'emploi page 18

OPERATING PROCEDURE
FILt
1
MODE
ZERO
MODE
ZERO
MODE
TARE
ZERO
AUt 0
2
MODE
ZERO
MODE
ZERO
MODE
TARE
ZERO
ZEro
3
MODE
TARE
OPERATING PROCEDURE
SPEGn
4
MODE
ZERO
MODE
TARE
ZERO
Funct
5
TARE
ZERO
MODE
TARE
The display will show FILt that corresponds to the digital filter allowed for
selection
By pressing MODE you enter the digital filter selection, then
By pressing ZERO you switch to/from L no and L SI where:
L no standard filter
L SI oversized filter.
By pressing MODE you enter the selection
Set with ZERO a filter value 1to 9
By pressing MODE you store the selected parameter and go back to the setting
selection session.
By pressing TARE you move to the next parameter.(2)
By pressing ZERO you go back to the weighing state
The display will show Aut 0 which corresponds to automatic zero on power-on
By pressing MODE you enter the automatic zero selection, then
By pressing ZERO you switch to/from A no and A SI where:
A no automatic zero inhibited
A SI automatic zero enabled.
By pressing MODE you enter the selection
Set with ZERO and TARE a value of weight within which the automatic zero will
be made.
By pressing MODE you store the selected parameter and go back to the setting
selection menu.
By pressing TARE you move to the following parameter.(3)
By pressing ZERO you go back to the weighing session
The display will show -ZEro- which corresponds to the zero setting
When the dynamometer is discharged, press MODE to perform the zero-
setting and automatically leave the settings in order to perform a visual check
of the setting made.
Press TARE to move to the next parameter.(4)
The display unit will show SPEGn which corresponds to timed switching-off
Press MODE to enter the switch-off selection, then
Set the switching off time with ZERO and TARE (minutes)
Press MODE to store the selected parameter and go back to the setting
selection.
Press TARE to move to the next parameter.(5)
Press ZERO to go back to the weighing state
The display will show Funct, which corresponds to the peak or hold function
selection
Press MODE to enter the function selection, then
Press ZERO to switch to/from F no, PEAK e HOLd where:
F no No function enabled
PEAK Peak measurement function enabled.
HOLd Weight block function enabled.
Press MODE to store the selected parameter and go back to the setting
selection.
Press TARE to move to the following parameter.(6)
18