Philips PerfectCare Elite GC9600 Série Mode D'emploi page 10

ENGLISH
Problem Possible cause
cover becomes ironing board cover after a long
ironing session.
ironing.
appliance.
Water droplets
soleplate.
come out from
CALC knob.
12
The ironing board Steam has condensed on the
wet or there are
water droplets on
the garment during
You have an ironing board cover
that is not designed to cope
with the high steam rate of the
The steam that was still present
come out of the in the hose has cooled down and
condensed into water. This causes
water droplets to come out of
the soleplate.
Steam and/or water The EASY DE-CALC knob is not
tightened properly.
under the EASY DE-
Storage
1 Switch off the appliance and unplug it.
2 Remove the water tank and empty it.
3 Put the iron on the iron platform. Push the carry lock to lock the
iron onto the platform.
4 Fold the supply hose and mains cord. Put them in their respective
storage compartments.
5 You can carry the appliance with one hand by the handle of the iron.
Do not carry the appliance by holding the water tank release lever.
Troubleshooting
the information below, visit www.philips.com/support for a list of
country.
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
frequently asked questions or contact the Consumer Care Centre in your
Solution
board cover to prevent condensation on
seconds.
knob.
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
the ironing board. You can buy felt in a fabric
shop.
Put an extra layer of felt material under
the ironing board cover to prevent
condensation on the ironing board. You can
buy felt in a fabric shop.
Steam away from the garment for a few
Switch off the appliance and let the
appliance cool down for 2 hours. Unscrew
the EASY DE-CALC knob and screw it back
onto the appliance properly. Note: Some
water may escape when you remove the