Trouble Shooting; Disposal And Recycling - Dexter 150MD2.5 Mentions Légales & Consignes De Sécurité

Suspected malfunctions are often due to causes that the users can fix themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within these instructions! All
further inspection, maintenance and repair work must be performed by an
authorised service centre or a similarly qualified specialist if you cannot solve the
problem yourself!
Possible cause
Problem
Not connected to power supply
Product does
not start
Power cord or plug is defective
Other electrical defect to the product
Extension cord not suitable for
Product does not
operation with this product
reach full power
Power source (e.g. generator) has too low voltage
Air vents are blocked
Unsatisfactory result Accessory is worn
Accessory not suitable for workpiece material
Electrical products must not be thrown out with domestic waste. Recycle them at the special disposal centers provided for the
purpose. Contact your local authorities or stockiest for advice on recycling.
The potential cts on the environment and human health as a result of the presence of hazardous substances in electrical and
electronic equipment.
For disposal, this tool also can be returned to the hardware store or vendor (or Dexter power dealer).

8. TROUBLE SHOOTING

Solution
Connect to power supply
Check by a specialist electrician.
Check by a specialist electrician
Use a proper extension cord
Connect to another power source
Clean the air vents
Replace with a new one
Use proper accessory

9. DISPOSAL AND RECYCLING

175
FR
ES
PT
IT
EL
PL
UA
RO
EN