Maintenance; Application Area; Storage Conditions; Trouble Shooting - Dexter 20VID3-60BLA.1 Mentions Légales & Consignes De Sécurité

7. MAINTENANCE

The impact drill is designed for using and charging in temperature regions with a characteristic
temperature of 0 ° C to 50 ° C, relative humidity not more than 80%,the absence of direct exposure
to atmospheric pre capitation and excessive dust content of the air.
Do not use power tools in explosive areas where flammable liquids, gases, dust are present. It creates
sparks, which can lead to the ignition of dust, steam.
Shelf life - 4 years provided that the products are stored indoors with natural ventilation in the
package at an air temperature of --20 ° C to 40 ° C and a relative humidity of not more than 80%

8.TROUBLE SHOOTING

Problem
The machine stops working
after rotating slowly.
The drill bit or screwdriver bit
easy to fall off.
Abnormal sound of gearbox.

Application area

Requirements for room conditions

Storage conditions

Possible Causes
The battery is in low power.
The drill bit or other screwdriver
bit is not tightly clamped with
the chuck
The speed selector is not in
place
Likely solutions
Need to charge the battery pack
before operating
Put the drill bit or screwdriver
bit into the middle of the three
jaws of the chuck, re-tighten
and visually check the drill bit
or the screwdriver bit without
tilting.
you need to push the speed
selector in place (before or
behind).
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN
215