for_q FQ-ELH 2500 Mode D'emploi page 100

c) Wear protective gloves, sturdy
shoes and long trousers.
d) Do not allow hands or any other
part of the body or clothing in-
side the intake opening, discharge
chute, or near any moving part.
e) During operation, do not reach
into the intake opening. The ma-
chine runs on for a few seconds
after being switched off.
f) If the cutting mechanism strikes
any foreign objects or if the ma-
chine should start making any
unusual noise or vibration, imme-
diately switch off and allow the
machine to stop. Remove the plug
from the mains supply and take
the following steps:
- Inspect for damage.
- Check for and tighten any loose
parts.
- Replace or repair damaged
parts with original components
if necessary.
g) Keep proper balance and footing
at all times. Do not overreach.
Never stand at a higher level than
the base of the machine when
feeding material.
h) Keep extension cords away from
the shredding means. The shred-
ding means can cause damage to
the cords and lead to contact with
live parts.
i) Always stand clear of the dis-
charge zone when operating the
machine.
j) If the machine becomes clogged,
switch off and allow the cutter to
stop. Remove the plug from the
mains supply before clearing de-
bris.
k) When feeding material into the
machine be extremely careful that
pieces of metal, rocks, bottles,
cans or other foreign objects are
not included.
l) Do not tilt the machine while it is
running.
EN
100
m) Never transport, pick up or carry
the machine while the motor is
running.
n) Switch off, allow the cutter to
stop and remove the plug from
the mains supply whenever you
leave the work area.
o) Do not allow processed material
to build up in the discharge zone;
this may prevent proper discharge
and can result in kickback of ma-
terial through the intake opening.
p) Do not force the appliance. It is
working safer and better at the in-
tended workload range.
q) Do not run over, crush or pull
the extension cable, otherwise it
may be damaged. Protect the ca-
ble from heat, oil, heavy load and
sharp edges.
r) Do not use the machine in the rain,
during danger of lightning or leave
it outdoors when it is raining.
s) Empty the collection box fre-
quently. Do not wait until the col-
lection box is completely full as
this can cause blockage at the ex-
traction chute.
MAINTENANCE AND STORAGE
a) When the machine is stopped for
servicing, inspection, or storage,
or to change an accessory, switch
off and remove the plug from
the mains supply and allow the
machine to cool. Make sure that
all moving parts have come to a
complete stop before making any
inspections, adjustments, etc.
b) If an extension cord is used it shall
not be of lighter grade than the
supply cord already fitted to the
appliance.
c) Check the supply and any exten-
sion cord regularly for damage or
signs of ageing. Do not use the ap-
pliance, if the cords are damaged.
d) When servicing the cutting means
be aware that, even though the