Basic Operations - Fiat CLARION PU2312 Mode D'emploi

Adjusting the balance
1. Press A-M button 2 and select "BAL".
2. Turning the Rotary knob % clockwise empha-
sizes the sound from the right speaker; turning it
counterclockwise emphasizes the sound from the
left speaker.
* The factory default setting is "0"
(Adjustment range: L9 to R9)
3. When the adjustment is complete, press A-M
button 2 several times until the function mode
is reached.
Adjusting the fader
1. Press A-M button 2 and select "FAD".
2. Turning the Rotary knob % clockwise empha-
sizes the sound from the front speakers; turning
it counterclockwise emphasizes the sound from
the rear speakers.
* The factory default setting is "0".
(Adjustment range: F9 to R9)
3. When the adjustment is complete, press A-M
button 2 several times until the function mode
is reached.
Loudness
The loudness effect emphasizes the bass and tre-
ble to create a natural sound tone.
When you are listening to music at a low volume,
it is recommended to use the loudness effect.
● Turning on and off the Loudness Effect
Pressing and holding LD button 2 for 2 seconds
or longer turns the loudness effect on and off.
When the loudness effect is turned on, "LD"
appears in the display.
Switching display
Press DISP button 6 to select the desired dis-
play.
The display switches in the following order:
Main ➜ Clock (CT) ➜ Main ...
* If the display is changed by other button oper-
ation when the clock (CT) is displayed, the
clock display returns automatically after the
operation.
* The example shows the display in radio mode.
CT (Clock Time) function
The CT function enables you to display clock time
only when CT data is received.
Press DISP button 6, the display switches to CT
(Clock Time).
* When no CT data is received, "CT--:--"
appears in the display.
Note:
• There are some countries and stations where
clock time data are not transmitted. In some areas,
the CT may not be displayed correctly.
Automatic muting during
a phone call
If a cellular telephone is fitted, the volume of the
selected source will be automatically muted dur-
ing telephone calls and the message TEL MUTE
will appear on the display.
Press button # and pre-set station button 5 ! at
the same time to switch the function on.

Basic Operations

9