Power Supply - Gigahertz Solutions HF32D Mode D'emploi

Made in Germany
ways including their higher harmonics we offer a broad range of
affordably priced instruments with high professional standards.
Please refer to our homepage for comprehensive coverage.

Power Supply

Changing the Battery
The battery compartment is at the back of the analyzer. To re-
move the lid, press on the grooved arrow and pull the cap off. The
foam pad inserted pushes the battery against the lid preventing
the heavy battery from rattling. This is the reason for the lid's re-
sistance during opening.
Auto-Power-Off:
This feature conserves energy and extends the total operating
time.
1. In case you have forgotten to turn OFF the HF analyzer or
it has been turned ON accidentally during transport, it will
shut off automatically after 40 minutes of continuous use.
2. If "LOW BATT" appears vertically between the digits in the
centre of the display, the HF analyzer will turn OFF after 2
to 3 min in order to avoid unreliable measurements. It re-
minds you to change the battery as soon as possible.
Shielding done by an expert is a depend-
able remedy
The effectiveness of shielding done by an experienced craftsman
can be verified by measurement. He has quite a number of op-
tions at his disposal. There is no "best method", however, befit-
ting for all problems – shielding always has to be adapted to the
specific situation.
Shielding, too, is covered comprehensively on our homepage
which also contains further links on this issue
Warranty
We provide a two year warranty on factory defects of the HF ana-
lyzer, the antenna and accessories.
Antenna
Even though the antenna appears to be rather delicate, it is made
of a highly durable FR4 base material that can easily withstand a
fall from table height.
HF Analyzer
The analyzer itself is not impact proof, due to the comparatively
heavy battery and the large number of wired components. Any
damage as a result of misuse is excluded from this warranty.
14
© Gigahertz Solutions GmbH