Projector Lamp; About The Projector Lamp; Replacing The Projector Lamp - Sony LMP-H400 Mode D'emploi

Projector Lamp

About the Projector Lamp

The LMP-H400 Projector Lamp is designed
for use with the Sony projector.
Be sure to confirm that this lamp is usable
with your projector before using it by
reading the Operating Instructions supplied
with the projector.
Also, the air filter is supplied with the LMP-
H400 Projector Lamp. When you replace the
lamp, it is also time to replace the air filter.
Whenever you replace the lamp, be sure to
replace the air filter with a new one.
For detailed information on how to replace
the filter, see "Air Filter" on page 5.
Caution
• The lamp remains hot after the projector is
turned off. If you touch the lamp, you may
burn your fingers. When you replace the
lamp, turn off the projector, then unplug
the power cord. Wait for at least an hour
for the lamp to cool.
• Do not touch the surface of the lens. If you
touch it, wipe off the fingerprints with a
soft cloth.

Replacing the Projector Lamp

The illustrations below show the case of
replacing the lamp with the projector
installed on the floor or desk.
Pay special attention to replacing the
lamp when the projector is installed on
the ceiling.
1
Turn off the projector and unplug
the AC power cord.
2
Place a protective sheet (cloth)
beneath the projector.
Note
Be sure that the projector is placed on a
stable surface.
2
GB
Projector Lamp
3
While holding up the cover
release lever on the right, slide the
top cover until it stops.
Cover release lever
4
Loosen the screw on the lamp
cover with a Philips screwdriver,
and then open the lamp cover.
Note
Be sure to use a Philips screwdriver with a
shaft length of 130 mm (5
more when replacing a projector lamp.
1
/ inches) or
8