Villeroy & Boch ProDetect 2 Mode D'emploi page 78

Fault diagnosis
Fault
Water discharge has
been detected
S. 78
Possible cause
Hoses are leaking
Fault rectification
Make sure that the connection
•
spigot has been pushed into the
water connection adequately and
is properly sealed.
Make sure that the seals and the
•
sieve seal on the inlet and outlet
of the solenoid valve have been
mounted in the correct position.
Make sure that the two union
•
nuts on the inlet and outlet of
the solenoid valve are tightened
adequately and properly.
Make sure that the hose
•
connections are screwed into the
connection spigot adequately.
Make sure that the seal ring on
•
the connection spigot is fitted
correctly.