König Electronic IR-URC30 Mode D'emploi page 4

Press any key to stop search if your device reacts,
then test the key functions.
Set-up by Enter Code
1. Switch on the device, which you would like to control (e.g. TV set).
2. In the back section of this manual, find the brand name and code number of
your device brand (e.g. Lifetec 003, 010, 062).
3. Press the SET key on your new remote control for more than 3 seconds,
then release it.
4. Press the ▲ or ▼ keys to select to CODE SETUP in the LCD menu, and
press the OK key.
5. The screen shows the DEV SEARCH in the LCD menu, press the ▲ or ▼
keys to select to CODE SETUP in the LCD menu, and press the OK key.
6. Then you press device key to select your desired operation device(e.g. TV)
and then press the OK key, you must now enter the 3-digit device code (e.g.
003 for Lifetec TV)
7. Press the OK key to save it and LCD shows SUCCESS, and press EXIT key
two times to exit the SETUP mode.
8. You check the function of the keys on the remote control. If most keys on
your new remote control do not function correctly, try another 3-digit device
code (e.g. 010...) from the list under the same brand. Repeat steps 3 to 7
until all the basic functions operate correctly.
Press code number. (e.g. 003)
Learning
Learn a Command
1. Press a device key (e.g. TV) where you want to learn to.
2. Press and hold the SET key for more than 3 seconds, then release it.
3. Scroll ▲ or ▼ key to LEARNING in the LCD menu, then press the OK key.
SET 3S
SET 3S
4
1S
1S