Audiophony PA WALLAMPtouch Guide De L'utilisateur page 24

Français
WALLAMPtouch - 2 x10W wall amplifier - SD/BT/Radio/AUX/USB with touch screen and line output
10 - Installation
Note: The flush-mounted box must not be less than 40 mm deep.
1 - Make an opening in the wall corresponding to the dimensions of the flush-
mounted box.
Drilling to be
reserved for
connection
2 - Secure the flush-mounted box securely with dowels suitable for the bracket.
3 - As shown in the figure below, unclip the front panel and gently remove the back
of the controller.