Velleman CAMSET13 Mode D'emploi page 3

e) Remote Controller
You can activate both the auto switch function and the single channel function (see above) with the remote control. This
is done in the same fashion as when the buttons on the A/V switcher are used.
For the auto switch function : press SCAN and the automatic sequence will start.
For the single channel function : press CH. ▲ or CH. ▼ to select a camera picture. Note that this function
automatically deactivates the auto switch function.
6. Specifications
a) Transmitters (four wired colour cameras)
Power Supply
Current Consumption
A/V Output
Resolution
Image Sensor
Pixels
Scanning System
Min. Illumination
S/N ratio
Automatic Shutter
Geometric Distortion
Gamma correction
AGC
Operating Temperature
Lens
Dimensions
b) Receiver (sequential A/V switcher with 4 inputs and remote control)
Power Supply
Current Consumption
A/V Input
A/V Output
Dwell Time
Dimensions
Adapter
CAMSET13 – A/V BEVEILIGINGSSYSTEEM MET 4 CAMERA'S & AFSTANDSBEDIENING
1. Inleiding
Dank u voor uw aankoop! Lees deze handleiding aandachtig voor u het toestel in gebruik neemt.
2. Inhoud
• 1 x A/V schakelsysteem met 4 ingangen
• 1 x afstandsbediening (12V batterij type GP23A meegeleverd)
• 4 x kleurencamera met montagebeugel
• 4 x 10m coaxkabel
• 1 x A/V kabel
• 1 x AC/DC adapter 10V/600mA voor de centrale eenheid
CAMSET13
DC 10V / 200mA
0.22W
1Vpp / 75 ohm
330 TV lines
1/3" CMOS
628 (H) x 582 (V)
2:1 interlace
0.5Lux with F2.0 lens
better than 46dB
1/60 – 1/15000 sec.
none
0.45
ON
-10°C to +50°C
6.0mm / F2.0
105 x 55 x 86mm (L x W x H)
DC 10V / 600mA
100mA
4 A/V inputs 1Vpp, 75 ohm
1 A/V output 1Vpp / 75 ohm
1 ~30 seconds
195 x 125 x 30mm (L x W x H)
DC10V / 600mA (included)
3 VELLEMAN