Troy-Bilt TB25CB Manuel De L'utilisateur page 23

ADJUSTING THE TRIMMING LINE LENGTH
(For units with bump heads)
If the unit is equipped with a bump head, trimming line can be released from the cutting head without
stopping the engine. Before doing so, make sure the cutting head is loaded with line. Refer to the Line
Replacement Addendum.
To release more line, lightly tap the bump knob on the ground (Fig. 16) while operating the unit at high
speed. For best results, tap the bump knob on bare ground or hard soil. Attempting to release line in
tall grass may stall the engine.
NOTE: Do not rest the cutting head on the ground while the unit is running.
Each time the bump knob is tapped, about 1 inch (25.4 mm) of trimming line is released.
NOTE: Always keep the trimming line fully extended. Line release becomes more difficult when the
cutting line gets shorter.
A blade in the cutting head shield will cut the line to the proper length if any excess line is released.
WARNING:
length will make the unit overheat. This may lead to serious personal injury or damage to
the unit.
TIPS FOR BEST RESULTS
• For most operations, cut from side to side.
• The direction that clippings are thrown depends upon the rotation of the cutting head. To direct
clippings away from the operator:
• Clockwise rotation: Tilt the cutting head slightly down to the left; cut from right to left
whenever possible.
• Counterclockwise rotation: Tilt the cutting head slightly down to the right; cut from left to
right whenever possible.
• Cut tall grass (over 8 inches (20cm)) from the top down by lowering the cutting head onto the grass.
• Cut with the tip of the trimming line.
• Cut in small increments. Move slowly. Do not force the unit.
Do not remove or alter the line cutting blade assembly. Excessive line
Fig. 16
23
Bump Knob