Whirlpool NTW5100TQ Mode D'emploi page 5

Straight power cord
Straight power cord
1. Remove power plug and yellow strap from machine base
to release the rear leveling system.
2. Firmly grasp the power cord and pull to completely remove
the power cord, cord restraint, and pin from the rear panel.
3. Con rm that the power cord restraint (A) and pin (B)
are removed.
A
A. Power cord restraint
B. Pin
B
4. To remove the power cord from the cord restraint, push the
power cord in, press TAB, and then pull the power cord out.
Looped power cord
Looped power cord
1. Firmly grasp the yellow shipping strap and pull until both ends
are completely removed from washer.
2. Check that two (2) cotter pins were removed with the shipping
strap.
5