Setting Up; Handling And Use; Suitable Laminating Pouches - UNITED OFFICE ULG 300 B1 Mode D'emploi Et Consignes De Sécurité

Setting up

For the safe and trouble-free operation of the device, the set-up location must
fulfil the following requirements:
■ Place the appliance on a firm, flat and level surface .
■ Set up the appliance so that there is enough free space in front of the laminator
to allow the pouch to come completely out of the laminator .
■ Do not operate the device in a hot, wet or extremely damp environment or
near flammable materials .
■ The mains power socket must be easily accessible, so that the power cable
can be easily disconnected in the event of an emergency .

Handling and use

In this chapter you will receive important information on the handling and opera-
tion of the appliance .

Suitable laminating pouches

For hot lamination, you can use pouches with a width of up to 320 mm and a
maximum thickness of 125 µm . Please note that each laminating pouch may only
be used once .
NOTE
► For hot lamination, use only laminating pouches that are expressly intended
for hot lamination .
► For cold lamination, use only laminating pouches that are expressly
intended for cold lamination .
► Take note that the laminating pouches supplied with the laminator are
intended exclusively for hot lamination .
■ 6 │ GB │ IE
ULG 300 B1