AEG PT 5675 Mode D'emploi page 37

• Move the tip of the shaving head in and out of the nostril or outer ear, using circling
movements.
Stop operation
Shut off the device after use by sliding the switch downwards. The switch shows "0".
Cleaning
CAUTION:
• Do not immerse the device in water. This could destroy the electronics.
• Do not use sharp or abrasive cleaning agents.
• Do not use a brush for cleaning the shaving foil of the shaver.
1. Switch off the appliance before cleaning. Revmove the battery.
2. You may wipe the housing of the device with a slightly damp cloth.
3. Remove hair residue after each use, e.g. using a cleaning brush.
4. The shaving head of the beard/ outline trimmer attachment as well as the shaving
foil holder of the shaver can be removed and rinsed under running water. Wait for all
components to be completely dry before reinstalling them.
Beard/ outline trimmer attachment
The shaving head is locked to the attachment.
1. Fig. A: Loosen the shaving head as shown in the picture. Hold
the shaving head with your other hand.
2. Remove hair residue with the cleaning brush, if necessary under
running water. Blow off residue from the shaving head or the
inside of the attachment.
3. Regularly apply 1-2 drops of acid-free oil onto the shaving
blade.
4. Fig. B – Installation: First place the shaving head at position 1
and then lock it at position 2.
English
37