Hamron 619-280 Mode D'emploi page 10

WARNING! Set the pump switch to "OFF" when connecting the battery clips.
Connection and starting
Irrespective of the type of oil to be pumped, the pump must be started as follows:
1. Turn the power switch to "OFF".
2. First connect the black clip to the battery's negative terminal.
3. Then connect the red clip to the battery's positive terminal.
4. Install the suction hose and pressure hose on the pump; where applicable, also connect the suction
probe.
5. Position the pressure hose in the vessel in which the oil is to be collected.
6. Position the suction hose as shown below.
7. Start the pump with the power switch (5).
Engine oil
Draw up engine oil as follows:
1. Warm up the engine until the oil reaches 40ºC to 60ºC.
2. Remove the dipstick.
3. Insert the suction probe into the hole for the dipstick until it reaches the lowest point in the oil pan.
Then start the pump and draw out the oil.
Diesel oil or fuel oil
Position the suction hose at the lowest point in the oil container and start the pump.
Stopping and disconnecting
Irrespective of the type of oil to be pumped, the pump must be stopped as follows:
1. Stop the pump with the power switch (5).
2. Disconnect the battery clips.
3. Disconnect the suction hose and pressure hose from the pump; where applicable, also disconnect
the suction probe.
4. Clean the parts. See "Maintenance".
Clean the appliance with a damp cloth and, if necessary, washing-up liquid. Never use solvents or
chemicals. This can damage the appliance.
Never store the pump and its parts with oil in the ducts. Always clean the pump before putting it away.
ENGLISH
OPERATION
MAINTENANCE
STORAGE
10