Makita DCO140 Manuel D'instruction page 6

Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this situation, turn the tool off and stop the
application that caused the tool to become
overloaded. Then turn the tool on to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before turning the tool on again.
Low battery voltage:
•
The remaining battery capacity is too low
and the tool will not operate. In this situation,
remove and recharge the battery.
NOTE:
The overheat protection works only with a battery
cartridge with a star marking.
1
012128
Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
2
015676
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
1. Star marking
1. Indicator lamps
2. Check button
1
Indicator lamps
Lighted Off
015658
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Adjusting depth of cut
2
014854
To adjust the shoe, loosen the thumb screw. Slide the
shoe to the desired position and then tighten the thumb
screw securely. Check for the proper clearance beneath
the workpiece before cutting not to strike a hard surface
such as the floor, workbench, etc.
Switch action
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the slide switch actuates
properly and returns to the "OFF" position when
the rear of the slide switch is depressed.
6
Blinking
75% to 100%
50% to 75%
25% to 50%
Charge the
The battery
malfunctioned.
1. Thumb screw
1
2. Shoe
Remaining
capacity
0% to 25%
battery.
may have