Overview; Handling Your Unit - Superior XB 6178 A Mode D'emploi

27311 AE waterkettle IM-A 8/7/06 3:35 PM Page 10

Overview /

Handling your Unit

Overview
(1) Filter
(2) Cover
(3) Cover-Lock-Button
(4) Control Light / Switch
(5) Handle
(6) Base Station
(7) Casing
Handling your Unit
Important notice:
Prior to using this device for the first time, we recommend cleaning it by boiling and discarding water once as per the following
instructions. This will remove any dust or residue remaining from manufacture.
• Place the base station on a stable, level and heat-resistant surface. Please be sure that the device cannot slide or tip over.
• Open the cover by pushing the cover-lock-button and pulling the cover handle up at the same time.
• Fill the tank with clear water. The water level must be between both water level marks (min./max.) of your unit. The device can
overheat if the water level is too low. Boiling water can splash out if the water level is too high.
• Close the cover; the device will automatically switch off when the water boils only if the cover is closed.
• Place the device on the base station and connect the power plug to a power outlet.
• Please be sure that the opening to pour fluids does not face toward a person as hot steam escapes from this opening during
boiling.
• Switch the main switch to "1", the control light will light up, indicating that the device is functioning. The water will now be
heated.
• Please be sure that the cover is tightly closed during boiling. Danger of Burns!
• After the water has come to a boil, the device will automatically switch off. The switch will jump back to "0", the control light
will go out.
• After heating the water, wait for a moment until the water no longer bubbles. Do not open the cover during boiling or pouring.
• The heating process will be shut off immediately if the device is lifted from the base station. The device will switch off.
• The water boiler is equipped with overheating protection. This will interupt the heating process of the device if it is switched on
without any water in the tank. In this case, the device must cool off for at least 15 minutes prior to filling the tank with water
and re-starting the heating process.
• Pull the power plug out of the power outlet if this device is not in use.
Composite
C M Y CM MY CY CMY
2
1
7
6
11
K
GB
3
4
5