Electrolux EAT967 Mode D'emploi page 5

PARTS
1. Toast slots
2. Carriage lever
3. Reheating button
4. Defrosting button
5. Stop button
6. Browning control knob (1-6)
7. Crumb tray
BEFORE FIRST USE
Remove all packaging materials and wipe the outside of the appliance with a damp cloth.
Before using the appliance for the first time, it is recommended to let the appliance complete a few
toasting cycles without slices of bread on the highest browning setting in a properly ventilated room.
OPERATION
1. Plug the toaster into the mains socket.
2. Put the bread slice/slices into the slot(s) at the top of the appliance.
• Make sure the crumb tray is fully in place by pushing it firmly into the appliance before using.
3. Turn the browning control knob to the desired setting.
• There are 6 settings: "1" for the lightest setting, "6" for the darkest setting.
• You will need to experiment with this setting depending on your browning colour preference and the
thickness of the bread.
4. Press carriage lever down vertically until it locks in the down position to switch the appliance on.
• The indicator light on the stop button will illuminate.
• Toasting process can be terminated at any time by pressing
5. Once the bread has been toasted to the selected setting, the bread will automatically pop up and the
carriage lever will automatically spring up to switch off the appliance.
• During toasting, you may observe the toasting colour, if the browning setting is higher than
required, press to stop the operation at any time.
• The indicator light on the stop button will go out.
6. Remove the bread from the slot.
IMPORTANT:
If the bread gets stuck inside the appliance, do not attempt to dislodge the bread
when the appliance is plugged in. Remove the plug from the mains socket, allow the appliance
to cool down and carefully remove bread using wooden tongs.
7
5
3
3
1
4
. The carriage lever will spring up.
EN
2
6