Kohler Jacob Delafon DTV Prompt Manuel D'installation Et Guide De L'utilisateur page 4

•
Make sure that the item is installed by a competent installer.
•
Shut off the main water supply.
•
A licensed electrician should route all electrical wiring.
•
Disconnect power to the valve before servicing.
•
Observe all local plumbing, electrical and building codes.
•
Provide access for servicing the valve and the interface.
•
Installation must be carried out in accordance with these instructions, and must be conducted
•
The plumbing installation must comply with the requirements of UK Water regulations/Bye-
company or water undertakers.
•
This appliance must be earthed. Ensure supplementary bonding complies with the
"Requirements for Electrical Installations". The valve is intended to be permanently connected
•
Mains connections are exposed when the cover is removed.
•
Do not install the valve in any location where the temperature may reach temperatures over
40°C (104°F). The valve and its integrated power supply is rated to operate in temperatures
up to 40°C (104°F).
•
When possible, install the valve prior to installing the interface and install the electrical outlet
prior to installing the valve.
•
For optimum performance, dedicated water supply lines are recommended.
•
routed from the number 1 outlet port.
•
The valve contains plastic and rubber components which could melt.
•
Do not apply petroleum-based lubricants to the valve components.
•
Do not use oil-based, non-setting compounds, such as plumbers putty on the threaded
connections.
•
Flush all pipework prior to installing the valve.
•
The water supplies to this product must be isolated if the product is not to be used for a long
period of time. If the product or pipework is at the risk of freezing during this period they
should also be drained of water.
•
DO NOT operate this appliance if it is frozen. Allow the appliance to thaw before using. The
241
68
318
37
60
51
4
318
86
25
46
205
259
295
340