Bosch PSM VENTARO 1400 Notice Originale page 21

OBJ_BUCH-39-004.book Page 21 Tuesday, July 21, 2009 2:15 PM
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned beams
and boards
For face sanding and plan-
ing small irregularities
For finish and fine sanding
of hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Replacing the Sanding Plate
(see figure H)
Slide the SDS button for release of the sand-
ing plate 23 all the way to the right.
Remove the sanding plate 24.
Guide the sanding plate 24 from below
against the sanding plate holder and firmly
press them together.
Slide the SDS button for release of the sand-
ing plate 23 all the way to the left.
If, e. g., the front tip of the sanding sheet is
worn, you can also remove the complete sand-
ing plate and reattach it turned by 120°.
Bosch Power Tools
Specialty Sanding Plates
You can replace the supplied sanding plate 24
with a specialty sanding plate, which is available
as an accessory.
Grain size
The specialty sanding plate is attached in the
same manner as the one supplied.
40—180
Attach and remove the respective sanding
sheets in the same manner as when changing
original sanding sheets.
coarse 40
Pad Extender (see figure I)
With the pad extender 26 you can sand surfaces
that are difficult to access, such as sills on win-
medium 80, 120
dows, cabinets or doors.
Pad Extender, Narrow (see figure J)
fine 180
With the narrow pad extender 28 you can sand
narrow openings, slots and passages.
40—180
Pad Extender, Narrow Rounded (see figure K)
The narrow rounded pad extender 29 allows you
to sand curved and hollow areas or surfaces that
are curved inward, such as on furniture, rails or
coarse 40
heating radiators.
medium 80, 120
fine 180
Operation
Starting Operation
Observe the correct mains voltage! The
voltage of the power source must agree
with the voltage specified on the nameplate
of the vacuum cleaner. Vacuum cleaners
marked with 230 V can also be connected to
220 V.
Switching On and Off
Switch the vacuum cleaner on when the
sander is set at "0". After switching off,
wait until the sander has come to a stand-
still before placing it down. The sander can
move unintentionally.
Completely unreel the cable before putting
the vacuum cleaner into operation. The ca-
ble can heat up.
English | 21
1 609 929 S60 | (21.7.09)