Bosch PSM VENTARO 1400 Notice Originale page 16

OBJ_BUCH-39-004.book Page 16 Tuesday, July 21, 2009 2:15 PM
16 | English
Safety Notes
en
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
Save these instructions.
Safety instructions for the sander with
the vacuum cleaner
Keep the vacuum cleaner away
from rain and moisture. Do not
vacuum liquids and use the sand-
er only for dry sanding. Water en-
tering the vacuum cleaner increas-
es the risk of an electric shock.
Keep your work area clean and well lit. Clut-
tered benches and dark areas invite acci-
dents.
Keep children and other persons away
while operating the sander. Distractions can
cause you to lose control over the machine.
Stay alert, watch what you are doing and
use common sense when working with the
sander. Do not use the machine while tired
or under the influence of drugs, alcohol or
medication. A moment of inattention while
operating the machine may result in serious
personal injury.
Wear personal protective equipment and al-
ways wear safety goggles. Depending on the
type of sander and the application, the wear-
ing of personal protective equipment such as
a dust mask, protective gloves, or hearing
protection, reduces the risk of injuries.
Dress properly. Do not wear loose clothing
or jewellery. Keep your hair, clothing and
gloves away from moving parts. Loose
clothes, jewellery or long hair can be caught
in moving parts.
Store the idle sander and vacuum cleaner
out of the reach of children. Do not allow
persons unfamiliar with the equipment or
who have not read the instructions to use
the sander and vacuum cleaner. Tools are
dangerous in the hands of untrained users.
1 609 929 S60 | (21.7.09)
Do not use the vacuum cleaner when the
mains cable is damaged. Do not touch the
damaged cable and pull the mains plug
when the cable is damaged while working.
Damaged cables increase the risk of an elec-
tric shock.
Do not vacuum materials that are harmful to
one's health, e. g. dust from beech or oak
wood, masonry dust, asbestos. These mate-
rials are considered carcinogenic.
When operating the vacuum cleaner in
damp environments, use a residual current
device (RCD). Using a residual current de-
vice (RCD) reduces the risk of an electric
shock.
Make sure that the switch of the sander is
in the "0" position before switching on the
vacuum cleaner. This safety measure pre-
vents unintended starting of the sander.
Do not use the sander if its "On/Off" switch
is defective. A machine that cannot be con-
trolled with the switch is dangerous and
must be repaired.
Caution, fire hazard! Avoid overheating the
object being sanded as well as the sander.
Always empty the dust collector before tak-
ing breaks. In unfavourable conditions, e. g.,
when sparks emit from sanding metals, sand-
ing debris in the dust bag, micro filter or pa-
per sack (or in the filter sack or filter of the
vacuum cleaner) can self-ignite. Particularly
when mixed with remainders of varnish, poly-
urethane or other chemical materials and
when the sanding debris is hot after long pe-
riods of working.
Use the sander, accessories and tool in-
serts, etc., according to these instructions
and as prescribed for this specific machine
type. Take the working conditions and pro-
cedure into account. Use of the sander for
applications other than intended for can lead
to hazardous situations.
Provide for good ventilation at the working
place.
Bosch Power Tools