Table des Matières
Publicité
3.3.8 INITIAL FIRING
When lit for the first few times, the appliance may emit an odor resulting from evaporation of paint and
lubricants used in the manufacturing process. Open a door or window for ventilation. Anyone with a
respiratory condition may need to leave the room during the initial firings.
It is normal for the appliance to expand and contract while it heats up or cools down
whether this is from a cold start or a steady-state condition where the fan has come on
or off. Under these circumstances it is possible that the expansion/contraction of the
Il est normal que l 'appareil à dilater et se contracter pendant qu'elle se réchauffe ou se
refroidit s'il s'agit d'un démarrage à froid ou d'un état d'équilibre où le ventilateur est
venu sous ou hors tension. Dans ces circonstances, il est possible que l'expansion et
la contraction des pièces métalliques peuvent produire des sons
Occasionally, after a cold start, vapor may condense and fog the glass, and the flames may be
partially blue. After a few minutes the moisture will disappear and the flames will become yellow.
Visually check the flame after warm-up.
3.3.9 MANIFOLD PRESSURE REGULATOR ADJUSTMENT
The manifold pressure regulator controls gas input and flame height, and is pre-adjusted at the
factory. No further adjustment is required.
PILOT FLAME ADJUSTMENT
For proper operation, the pilot and main burner flames must be steady and not lifting off or floating.
The top 3/8" – 1/2" (10-13mm) of the thermocouple should be engulfed by the pilot flame.
PRIMARY AIR ADJUSTMENT
Aeration is factory set but may need adjustment for altitude or movement during shipping.
To adjust the air shutter:
1/. Turn off the gas
2/. Remove the door
3/. Remove the logs
4/. Remove the brick panels by sliding the two side panels forward then lift the back panel up and
over the pilot assembly and then down and out.
5/. Remove the burner tray by removing the 5 mounting screws
6/. Unscrew the burner from the base of the fireplace, slide to the left and lift out.
7/. Undo the set screw on the air shutter and adjust accordingly then retighten the set screw.
8/. Reassemble the fireplace in reverse order from 6 through 2.
9/. Turn on the gas.
CAUTION
ATTENTION
metal parts may produce sounds.
PARTS REQUIRING ADJUSTMENT DURING OPERATION MAY BE HOT.
PIECES NECESSITANT REGLAGE PENDANT LA MARCHE PEUT ETRE CHAUDE
Page 32 of 52
Publicité
Table des Matières
