Digital On/Off Remote; Direct Vent Information - Inca Metal Cutting ABBOT-30-PG-PREM Manuel D'installation Et Guide De L'utilisateur

Table des Matières

Publicité

WARNING
AVERTISSEMENT
DO NOT USE AN OPEN FLAME TO TEST FOR GAS LEAKS
NE PAS UTILISER UNE FLAMME DE TEST DE FUITES DE GAZ
3.3.3 DIGITAL ON/OFF REMOTE INSTALLATION
This appliance comes with a remote hand held control unit only, see 1.2 Features section

3.3.4 DIRECT VENT INFORMATION

The unit must be connected to listed 2-ply aluminium venting, 3" flex vent on the exhaust side and
listed 3" flex vent on the air intake side. Install the vent components according to the manufacturer's
instructions.
L'unité doit être raccordée à l'aluminium 2-plis énumérés ventilation, 3 "flex évent sur le côté de
l'échappement et énumérés 3" flex évent sur le côté d'admission d'air. Installer l'évent composants
selon les instructions du fabricant.
Minimum allowable venting height is 10' with a 4' offset on a minimum 45 degree angle.
Maximum allowable venting height is 30'.
La hauteur minimale permise de ventilation est de 10 'avec un 4' offset sur un angle de 45 degrés
minimum.
If at any time the vent-air intake piping is dismantled, use the vent manufacturer's
instructions and the sealing instructions for reassembly.
Si à tout moment de la tuyauterie d'admission d'air de ventilation est démontée, utilisez
la ventilation instructions du fabricant et les instructions d'étanchéité pour le
remontage
Page 18 of 52

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Abbot-30-bl-premAbbot-30-pg-deluxeAbbot-30-bl-deluxe

Table des Matières