Switching Your Midland Bt Single On And Off; Pairing With Bluetooth Devices - Midland BT Single Guide D'utilisation

Switching your Midland BT SINGlE
on and off
BT Single can be switched on by means of the central button
labeled "Music".
To switch off the unit you must use a combination of two but-
tons (Music+AUX), thus lessening the chances that you might
turn off the unit accidentally (especially whilst wearing heavy
gloves).
Switching the unit on:
› Press and hold "Music" button down for approximately 3
seconds until the BlUe indicator lights.
Switching the unit off:
› Press and hold both "Music" and "AUX" buttons together
for approximately 3 seconds until the ReD indicator flashes
3 times.

Pairing with Bluetooth devices

Your Midland BT Single is a Bluetooth unit that can be paired
with other Bluetooth devices.
Before performing this procedure, it is necessary to set BT
Single into "Pairing mode" (Setup).
The only operations permitted in this mode are the pairing
ones. To use the BT Single unit after pairing it with the desired
devices, it is necessary to quit the "Setup" mode and switch to
the "Operating" mode.
6
Setup mode
Switch off the BT Single device. Press and hold down the cen-
tral button (Music/on) for about 7 sec. until the red indicator
switches on permanently. BT Single is now in "Setup" mode
and can therefore be paired with other devices.
Pairing the unit with your mobile phone
1. enable the Bluetooth device search feature on your mobile
phone. As this procedure varies according to the brand and
model of the mobile phone, refer to the manual supplied to
your particular phone for further information.
2. Set the BT Single unit in "Setup" mode, then press the
"Phone" button on the unit until the red and blue indicators
start flashing.
3. After a few seconds the mobile phone will display "Midland
BT Single". Select it and follow the instructions provided
in your mobile phone manual to accept the pairing. When
prompted, enter the pairing code, which is 0000 (four zero-
es). Your mobile phone should then display a confirmation
message if the pairing operation has been successfully
completed (in case of error message, complete anyway
the procedure, exit the "setup" mode and try to use the BT
Single with your phone).
4 The BT Single unit returns to the Setup mode (red indicator
permanently on) to indicate that it is ready to be paired with
other devices
if you pair the BT Single unit with a mobile phone, you will
not be able to pair it with a gPS Sat-nav, because both these
devices are assigned (high) priority 1.
This problem can be easily solved by pairing your mobile pho-
ne directly with your gPS Sat-nav and then pairing the gPS
with your Midland BT Single using the above procedure. in
this case, the mobile phone features will be managed by the
gPS Sat-nav.
Pairing the unit with a GPS Sat-Nav
it is generally possible to pair the BT Single unit with all gPS
Sat-navs that support Bluetooth earpieces.
Midland BT Single has been successfully tested for use with
gPS ZUMO Sat-navs manufactured by garmin and TOM-
TOM Rider 1 and 2 Sat-navs.
1. On your gPS Sat-nav, enable the Bluetooth earphone
search feature. As this procedure varies according to the
brand and model of gPS, we recommend you refer to the