Ansmann Energy DIGISPEED 4 ULTRA Mode D'emploi page 5

GB
OPERATING INSTRUCTIONS DIGISPEED 4 ULTRA
USE OF THE CHARGER
Super-speed-charger for 1-4 NiCd or NiMH batteries of the sizes Micro
(AAA) or Mignon (AA); Powered by 110-240 V AC adaptor
FEATURES
Separate charging processes for each battery inserted (individual
supervision of each cell position); Faulty cell detection; Automatic start
of the charging process once the batteries make contact regardless of
the charging status before insertion; NiMH or NiCd selected via switch;
Microprocessor control of the charging status; –delta V control and safety
timer; Temperature safety cut-off; Safety timer; Trickle charging; Automatic
matching of charging current; Protection against reverse polarity; LED
charging status indicators for each cell
INDICATORS
LED red: battery is being fast charged
LED red flashes: The charging current is cut off. 1. Defective cell (change
battery) 2. Rechargeable battery incorrectly inserted (insert again checking
polarity) 3.Disposable battery inserted (remove battery)
LED green: battery is fully charged. After termination of fast charging the
unit switches over to trickle charging. The cells may be left in the charger
until they are needed without being overcharged or losing capacity.
WARNING!
Due to the very high Charging current it is very important to charge
only Fast rechargeable cells. We recommend that you use the cells we
delivered together with the charger. Only charge either NiMH or NiCd
batteries with the correct switch position. Never mix both battery types.
Danger of explosion if other types of batteries (Alkaline, RAM etc.) are
inserted or switch in wrong position.
Safety
Keep charger in a dry place (indoor use only). In order to avoid the risk of
fire and/or electric shock, the unit must be protected against high humidity
and water. Do not use if there are signs of damage to the housings, cables
or connectors
OPERATION
Place the charger on a level surface and ensure that the vents are not
covered. Select either NiMH or NiCd using the selector switch. Once the
unit is connected to the mains (see type plate), and the corresponding
(NiMH or NICd) rechargeable battery is inserted, the charging process
starts automatically. When inserting the batteries please pay attention to