What To Do If - AEG SDS51400S0 Notice D'utilisation

Masquer les pouces Voir aussi pour SDS51400S0:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. When defrosting is completed, dry the interior thoroughly.
5. Switch on the appliance.
6. After two or three hours, reload the previously removed food into the compartment.
Never use sharp metal tools to scrape off frost from the evaporator as you could damage
it.
Do not use a mechanical device or any artificial means to speed up the thawing process
other than those recommended by the manufacturer.
A temperature rise of the frozen food packs, during defrosting, may shorten their safe
storage life.
Periods of non-operation
When the appliance is not in use for long periods, take the following precautions:
• disconnect the appliance from electricity supply
• remove all food
• defrost
8)
• leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it once in a while to prevent the
food inside from spoiling in case of a power failure.

WHAT TO DO IF...

WARNING!
Before troubleshooting, disconnect the mains plug from the mains socket.
Only a qualified electrician or competent person must do the troubleshooting that is not
in this manual.
There are some sounds during normal use (compressor, refrigerant circulation).
Problem
The appliance does not op-
erate. The lamp does not
operate.
The lamp does not work.
The compressor operates
continually.
8) If foreseen.
and clean the appliance and all accessories
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket correct-
ly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set cor-
rectly.
Possible cause
What to do if...
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
31

Publicité

Table des Matières
loading

Table des Matières