Livington FITMIX SMART Mode D'emploi page 9

OPERATION
1. Remove all packaging material and discard it in accordance with local laws and regulations.
2. Clean the blender and all components before using it for the first time. (See Cleaning)
3. Chop the ingredients e.g. fruit and vegetables into small pieces. Empty the chopped ingredients into the To-Go container (1).
Fill the container up to a maximum of 2/3 of its capacity. Always add a little liquid to fruit or vegetables, otherwise some types
cannot be chopped up into small pieces.
4. Screw down the blade attachment on the (2) in a clock-wise motion auf den To-go container (1).
5. Place the To-Go (1) container onto the motor unit. (3). Take care to line up arrow indicators
the mark on the motor unit (3). Turn the To-Go container (1) in a clockwise motion until it sits tightly in place.
Caution: this appliance can only be switched on using the correct To-Go container The safety switch off prevents
operation without the To-go container (1)
6. Plug in the appliance.
7. Select your required programme using the programme button (4) to start blending. Two pre-set programme options have
already been pre-programmed for you and set at the perfect speeds, so you can always choose between these or use the
PULSE button to ensure you always achieve perfect results.
Programme: recommended for:
P1* The preparation of soft fruit and vegetables,drinks & soups and egg white shakes.
P2* Creating smoothies, slushes and drinks, containing ice cubes, frozen fruit and hard fruit & vegetables.Pesto
PULSE Pulse mode: for chopping and crushing nuts, dried herbs, ice cubes & hard cheese.
* Please ensure that the appliance runs at intervals during a programme, so fruit and vegetables are blended together more
effectively. The programme has finished when the triangular LED display is fully illuminated Never remove the
To-Go container (1) with the blade attachment (2) until the display is fully illuminated. This may cause damage to the appliance
for which no liability can be accepted.
8. When the programme has ended, unplug the appliance.
9. Twist the To-Go container (1) off the motor unit (3). Then, turn the To-Go container (1) anti-clockwise and remove
by pulling upwards. Hold the To-Go container in your hand so the blade attachment (2) is pointing upwards.
10. Unscrew the blade attachment (2) in an anti-clockwise motion to remove it from the To-Go container (1).
You can now pour out your drink. The To-Go container (1) can be used as a drink bottle by adding a To-Go lid (5).
ICE CUBES
Fill the To-Go container (1) with a maximum of 6 ice cubes (or 12 small ice cubes) and some liquid. Always add liquid when you want
to crush ice cubes to achieve perfect results. Close the To-Go container by (1) by fitting the blade attachment (2). Screw down the
container onto the appliance. Now press the PULSE button (6) for a few seconds. If the ice cubes are still sitting at the bottom of the
To-Go container (1), you can press the PULSE button again (6). Repeat the process until you have achieved your preferred consistency.
MINI MIXER
The Mini Mixer enables you to grind spices, nuts, herbs, hard cheese, coffee and much more. Please note: only grind dry
ingredients (e.g., spices, nuts) in the mini mixer, never in the To-Go container. Never fill the mini mixer with liquid!
1. Add ingredients to the mini mixer (7) (max. 50g)
2. Screw the blade attachment (2) onto the mini mixer (7). Ensure that the mini-mixer is closed securely.
3. Put the mini mixer (7) onto the motor unit (3). Take care to line up arrow indicators
mark on the motor unit (3). Turn the mini mixer (7) in a clockwise motion until it sits tightly in place.
Warning: the appliance will only operate if the mini mixer (7) has been fitted correctly The safety shut off function
prevents the appliance from operating without the mini-mixer (7)
4. Connect the unit to the power supply.
5. Press the PULSE button (6) to start the grinding process. Then, press the 0/Pulse button (6) and continue until the ingredients
are ground to the desired fineness.
6. Twist the mini mixer attachment and blade unit in an anti-clockwise motion and lift them off the motor unit. Remove the
blade attachment (2) from the mini-mixer and pour the ground ingredients into a container. They can also be stored for later
use by adding the sprinkle lid (8).
Safety shutoff! The motor has a safety feature, and it switches itself off automatically in the event of an overload and will only
function again after cooling down.
Manual FitMix Smart_20170309_BA.indd 9
on the blade attachment (2) with the
9
on the blade attachment (2) with
09.03.17 11:48