Special Tools Safety Warnings - B+BTec Diamond3 AUTOMIXER Premium Manuel D'utilisation

GB
tained power tools .
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control .
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool
for operations different from those
intended could result in a hazardous
situation .
5) Service
a) Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained .
b) For power tools with type X attach-
ment, where a specially preparde
cord is needed to replace the cord:
if the supply cord of this power tool
is damaged, it must be replaced by
a specially preparded cord available
through a qualified service facilty .
SPECIAL TOOLS SAFETY
WARNINGS
Working safely with this machine
is possible only when the opera-
ting and safety information are
read completely and the instructi-
ons contained therein are strictly
followed. Before using for the
first time, ask for a practical
demonstration.
Before working on the machine
itself, pull the mains plug.
DIAMOND3
AUTOMIXER
®
WARNING!
• Avoid making contact with moving
parts during operation.
This may cause serious personal injury .
• Be sure that the switch is OFF before
plugging in.
Plugging in while the machine is
switched ON could lead to
serious injuries due to sudden move-
ment of the tool .
Dust and particules may cause eye
injuries and are hazardous to your
health .
• Replace damaged cords immediately.
Damaged cords may lead to electrocu-
tion .
• Use the shortest extension cord avail-
able.
The use of an extension cord that is
either too long or too thin will result in
a drop of voltage and poor machine
performance .
• Test the machine before use.
Make sure the machine is in proper
working order .
• Be careful when swiveling the tool
into the bucket or when using the
transportation handle.
Make sure the power cord or hands
don't get stuck between these moving
parts .
12
• Always wear safety
goggles and respira-
tory protection when
operating this tool.