Zipper Maschinen ZI-HAEK4100 Mode D'emploi page 29

ZIPPER MASCHINEN GmbH
ZI-HAEK4100 / ZI-HAEK11000
www.Zipper-Maschinen.at
Axis:
Tilt the blades chassis slightly
forwards, push the axis through the
bracket and fix with Allen screw,
washer and nut.
Wheels:
Place on both ends of the axis a
washer. Push a wheel over the axis.
Secure with a spacer and splint.
In-feed:
Place the in-feed on the blades
chassis so that the mounting holes
coincide with the holes on the in-feed.
Fix with screws, washers and nuts.
Attention: Risk of cutting!
Safety switch:
Insert the cable (a) into the plug of
the cable (b).
Then connect the cable (c) to the
motor using screw (d).
Discharge chute:
Place the discharge chute on the
blades chassis so that the mounting
holes coincide with the holes on the
discharge chute.
Fix with screws, washers and nuts.
ASSEMBLY
29