Thermador PRD304GHC Guide D'utilisation Et D'entretien page 13

IMPORTANT:
Always remove the Full Access
cleaning the oven. If the gliding racks remain in the oven
during Self-Clean, lubricants in the glide mechanisms of
each rack will be lost and the finish will discolor.
WARNING:
To help prevent burns, NEVER remove or reposition the
oven racks while the oven is ON or while the oven is
cooling.
WARNING:
Aluminum foil should never be used to cover the oven
racks or to line the oven. It can damage the oven and
cause a fire hazard if heat is trapped under it.
Placing Racks in the Oven:
Each gliding oven rack can be pulled out and pushed back
into the oven with minimal effort — even while supporting a
large turkey or roast.
Always remove
before Self Clean
English 8
®
oven racks before self-
Figure 2: Full Access Oven Rack
IMPORTANT
:
When placing the gliding rack in the oven, make sure the
front supports on the rack guides rest in the large slots at
the front corners of the rack. This is necessary to keep the
rack in the correct position while fully inserted into the
oven.
1. Hold the rack on a
slight angle. Place the
safety hooks under the
front of the rack guides.
2. Push the rack into the
oven, lifting the rack
stops over the front of
the rack guides.
3. Hold the rack straight.
4. Push the rack in until it
is even with the front
hooks.
5. Lift the rack up.
6. Push the rack in
completely.
7. Engage the rack's front
hooks on the rack
guides.
Figure 3: Inserting the Oven Rack