Remote Control - Honeywell MO08CESWS Mode D'emploi

USE & OPERATION (CONTINUED)

REMOTE CONTROL

The functions work the same as the Portable Air Conditioner's Control Panel.
All key functions can be accessed from the remote control.
Power Control
Fan Speed Control
Applicable for model MO08 Series:
Applicable for model MO10 Series:
Timer Control
In running mode: Auto switch off
In stand-by mode: Auto switch on
Press or button to adjust the
time setting for 1 hour intervals.
Note:
Battery Installation: Remove the cover on the back of the remote control and insert two AAA
batteries with + and - pointing in the proper direction according to the polarity markings.
Caution:
Use only two AAA or IEC R03 1.5V batteries.
Remove the batteries if the remote control is not in use for a month or longer.
All batteries should be replaced at the same time, do not mix with old batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Properly dispose of used batteries.
This device complies with part 15 of the FCC Rules. Operation is subject to following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment dose cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
ON / OFF
Temperature / Timer Set
Used for adjusting the timer and
temperature.
When the
set temperature is displayed and
may be adjusted
Timer setting is available from 1 - 24 hours
by pressing the key
Press this button to change the operation
mode in the order of:
Air Conditioning
EN 8
or key is pressed, the
or .
Mode Control
Dehumidifying
Fan