emerio RVC-120592.1 Mode D'emploi page 6

USE
1. Install the side brush as described above.
2. Place the machine on the ground to be cleaned.
3. Press the on/off button to turn on the machine with music playing accordingly. LED indicator is on; the
machine enters into standby status.
4. Press the start/pause button; the machine starts working.
5. During operation, press the start/pause button the machine will stop temporarily.
NOTE: The machine will automatically power off without working for approx. 60 seconds. Press the on/off
button to restart the machine if needed.
6. After use, press the dustbin release button to open the dustbin. Clean any dirt left behind in the dustbin.
NOTE: When machine stops unexpectedly and LED indicator flashes 3 times quickly in a second, please check
carefully if the machine is being entangled or brush wheel fails to operate.
- If the machine is being entangled, move it to the spacious place to restart.
- If the brush wheel fails to operate, take it out and make it clean.
- If the machine still cannot start properly, product malfunction happens. A long press on the on/off
button to power off the machine and start once again.
- If the malfunction cannot be recovered by its own, send the machine for repairing.
How to remove and reinstall the middle brush
Turn the machine upside down on a flat surface. Slide the middle brush release catch (B) and take out the
brush (C) and the side wheel (D). Clean the brush and the side wheel. Reverse the procedure to reinstall.
How to charge
When machine stops working and LED indicator flashes once slowly in a second, it means run out of battery.
Charge the machine in time.
1. Plug the adapter into the charging port next to the on/off button.
2. Plug the adapter into the power outlet.
3. During charging, the LED indicator will flash all the time.
4. When fully charged, the LED indicator will stay lit.
5. Plug out when finished.
- 5 -