Maintenance And Care; Information Regarding Environmental Protection; Contact - EUFAB 16542 Manuel De L'opérateur

Removing of charger
ATTENTION
First, pull the mains power plug from the socket and observe the sequence when disconnecting. This prevent the generation of sparks. This is
extremely important for your safety, as highly explosive oxyhydrogen is generated during the charging process.
Separate the charger from the supply network.
Then, remove the connection of the black clamp (-). Now, remove the battery clamp from the positive pole (+) of the battery.
Allow the battery to cool down and fi ll the cells with distilled water up to the level specifi ed by the battery manufacturer. Close the battery cells
with the stoppers.

MAINTENANCE AND CARE

Maintenance: The device is maintenance-free if used according to its intended purpose.
Care: Clean the pole clamps after each charging process. Remove all battery acid splashes from the pole clamps to prevent corrosion. Carefully clean the device
with a dry cloth. Do not use liquids or chemical cleaning agents. Never submerge the device in liquid. Never allow liquid to run over the device.
Insert the cable holders in the top bores of the casing screws on the back of the device. Properly roll up the cable before storing the device to prevent damage
to the cables and the device. Store the device in a dry and clean location.

INFORMATION REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of the device in household garbage. Electrical and electronic scrap has to be collected separately and disposed of in an environ-
mentally responsible manner for recycling. Please contact your community or city administration regarding disposal options for electronic
scrap.

CONTACT

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
6
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com