Oil Change; Air Cleaner; Inspection - Honda GX100 Manuel De L'utilisateur

Oil Change

Drain the used oil when the engine is warm. Warm oil drains
quickly and completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap/dipstick, oil drain plug and washer.
2. Allow the used oil to drain completely, then reinstall the oil
drain plug and new washer, and tighten the oil drain plug
securely.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground,
or pour it down a drain.
3. With the engine in a level position, fill with the recommended oil
(see page ) to the upper limit mark (bottom edge of the oil fill 7
hole).
Running the engine with a low oil level can cause engine
damage. This type of damage is not covered by the Distributor's
Limited Warranty.
4. Screw in the oil filler cap/dipstick securely.
OIL FILLER CAP/DIPSTICK
OIL FILL HOLE
(bottom edge)
DRAIN PLUG
SEALING WASHER
8

AIR CLEANER

A dirty air cleaner will restrict air flow to the carburetor, reducing
engine performance. If you operate the engine in very dusty areas,
clean the air filter more often than specified in the MAINTENANCE
SCHEDULE.
Operating the engine without an air filter element, or with a
damaged air filter element, will allow dirt to enter the engine,
causing rapid engine wear. This type of damage is not covered by
the Distributor's Limited Warranty.

Inspection

Remove the two screws and the air cleaner cover. Inspect the air
filter elements. Clean or replace dirty air filter elements. Always
replace damaged air filter elements.
Refer to page for cleaning instructions. 9
Reinstall the air filter elements and air cleaner cover.
PAPER AIR FILTER ELEMENT
FOAM AIR FILTER ELEMENT
(applicable types)
AIR CLEANER COVER
SCREWS
ENGLISH
AIR CLEANER CASE