Symbols - Stiga T 1.0 EJ Manuel D'utilisation

Masquer les pouces Voir aussi pour T 1.0 EJ:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 107
IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS
Maximum noise and vibration levels [1]
Sound pressure level
– Measurement uncertainty
Measured acoustic power level
– Measurement uncertainty
Guaranteed sound power level
Vibration level
– Measurement uncertainty
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric equipment
as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated. Safety
measures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions.
In this regard, all the operational cycle phases must be taken into consideration, such as switching off or idle running.
The noise level may vary according to machine usage if working or running idle.
TECHNICAL DATA
Power supply voltage
Power supply frequency
Engine Power
Cutting width
Mass
No-load Speed
Maximum engine and tool rotation speed

2. SYMBOLS

1
2
2
5
8
9
1) Warning! Danger. The failure to use this ma-chine cor-
rectly can be hazardous for oneself andothers.
3
4
6
7
10
2) Read the instruction manual before
using themachine.
3) If you are using the machine every day
in normal conditions, you can be ex-
posed to a noise level of 85 dB(A) or
higher. Wear earmuffs or ear-plugs, eye
protection and a protective helmet.
4) Danger of flying objects! Keep any pe-
ople orpets at least 15 m away when
using the machine!
5) Disconnect the plug from the mains be-
fore commencing maintenance work or
if the power cord is damaged.
11
6) Do not leave the machine in the rain (or
in damp conditions).
7) Only one cutting line head can be used
on thismachine.
8) Do not use pointed, rigid or metal bla-
des orcircular saw blades.
9) Keep bystanders away.
10) Cutting device rotation direction.
11) Acoustic output level LWA.
3
EN
T 1.0 EJ
dB(A)
79.3
dB(A)
3
dB(A)
88,2
dB(A)
3
dB(A)
96
m/s
2.5
2
m/s
1.5
2
T 1.0 EJ
V~
230
Hz
50
W
1000
cm
37
kg
4,70
min
7000
-1
r.p.m
7000

Publicité

Table des Matières
loading

Table des Matières