ESX Q201A Mode D'emploi page 10

AUDIO SIGNAL CABLES
When installing the audio cables between the RCA outputs of the head unit and the RCA inputs of the amplifier
[ 6 ], the audio and power supply cables should, if possible, not be routed along the same side of the vehicle.
We recommend a separated installation, e.g. routing the power cable through the cable channel on the left side
and the audio cables through the cable channel of the vehicle on the right side or vice versa. This prevents
interferences due to crosstalk into the audio signal.
PHASE SHIFT
LOW
POWER
PASS
0°
180°
AUTO TURN ON
50Hz 150Hz
PROTECT
Q 201A
ON
OFF
ACTIVE SUBWOOFER SYSTEM
HIGH LEVEL INPUTS & AUTO TURN ON
The high level inputs under HI LEVEL IN [ 7 ] is suitable to connect the device input with speaker wires, if your
head unit is not equipped with pre-amplifier RCA outputs. Extend therefor every regarding speaker cable from
your head unit with appropriate speaker cables from your car audio retailer to the mounting location of the am-
plifier. Then connect the each matching loudspeaker cable with the cables of the included High Level Input jack.
BASS INPUT
CAUTION: Never use the high level inputs and the RCA inputs at the same time. This may damage the
BOOST LEVEL
device seriously. Use the enclosed cable plug to connect each terminal.
0dB 12B MIN MAX
Q 201A
AUTO TURN ON
Push the AUTO TURN ON switch [ 8 ] to ON position. The amplifier detects now a voltage rise (6 Volts) over
the connected input signal on the HI LEVEL IN [ 7 ] when the head unit will be switched on. Hence, the amplifier
will also be turned on. As soon as the head unit will be turned off, the amplifier turns also automatically off. In
this case the turn-on connection [ 5 ] is not needed.
NOTE: The AUTO TURN ON function usually works with 90% of all head units, because they are equipped
with "High Power"-outputs. Only with a few older and still existing head units the Auto Turn On function is not
working.
INPUT SENSITIVITY
Turn the INPUT LEVEL [ 9 ] controller of the amplifier to the MIN position. Then turn the volume controller of the
head unit to 80 - 90% of its full setting. Now turn INPUT LEVEL [ 9 ] clockwise until you hear some distortion.
Then turn back INPUT LEVEL [ 9 ] slightly until you hear a cleaner sound.
PHASE SHIFT
POWER
AUTO TURN ON
PROTECT
10
REMOTE
BASS INPUT
BOOST LEVEL
6
0dB 12B MIN MAX
LINE INPUT
REMOTE
L
7
R
8
LOW BASS
PASS BOOST
9
0°
180°
50Hz 150Hz 0dB
Q 201A
ON
OFF
ACTIVE SUBWOOFER SYSTEM
LINE INPUT
POWER
L
R
HI LEVEL IN
POWER
FUSE
black/white
white
grey/black
HI LEVEL IN grey
PHASE SHIFT
LOW
POWER
PASS
0°
180°
AUTO TURN ON
50Hz 150Hz
PROTECT
ON
OFF
ACTIVE SUBWOOFER SYSTEM
REMOTE
INPUT
LEVEL
12B MIN MAX
FUSE
= L –
= L +
= R –
= R +
BASS INPUT
BOOST LEVEL
0dB 12B MIN MAX
Q 201A
LINE INPUT
L
R
LINE INPUT
REMOTE
L
R
POWER
FUSE
HI LEVEL IN