Numark NS7III Guide D'utilisation page 3

Setup
Before getting started:
•
Read the Safety & Warranty Manual before using NS7III.
•
Make sure all items listed in
1. Assemble the Platters
1. Remove NS7III from the packaging. Remove the two platter assemblies from package
(underneath NS7III). Place NS7III on a flat, stable surface for operation. Ensure unit has
adequate air flow to all ventilation ports (especially if installed in a case).
2. Place the platter onto NS7III by aligning the pins in the bottom of the
platter with the holes in NS7III's motor.
3. Place the slipmat onto the platter, then place the vinyl over the
slipmat.
4. Line up the notch in the spindle with the screw in the vinyl's 45
RPM adapter. Use the allen wrench (included) to tighten the
screw, locking the adapter to the spindle.
Introduction > Box Contents are included.
3