Hama Connect Mode D'emploi page 5

• The earphones are equipped with a rechargeable
battery. The battery must be fully charged before
using the device for the first time.
• Ensure that the earphones are switched off before
charging them.
• Begin charging by connecting the included USB
charging cable to the charging socket (7) as
well as to the USB connection of a PC/laptop.
• Alternatively, you can charge the earphones
using a suitable USB charger. Please refer to the
operating instructions for the USB charger used.
• The display lights up constantly in red during the
charging process.
• It takes around 2 hours until the battery is
completely charged.
• Once the charging process is complete, the red
light of the LED (3) turns to blue light.
• Disconnect all cable and mains connections
after use.
5. Operation
Switching the earphones on/off
• Press the MF button (5) until a voice says "Power
ON" and the blue LED flashes.
• To switch it off, press and hold the MF button
(5) until a voice says "Power OFF" and the red
LED flashes.
Note
The functions described in this section are only
available for Bluetooth
5.1. Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• The earphones and the terminal device should be
no further than one metre apart. The smaller the
distance, the better.
• Switch on the earphones with the MF button (5).
• Press and hold the MF button (5) until the red and
blue LEDs flash alternatingly. The earphones are
searching for a Bluetooth
• Open the Bluetooth
device and wait until Hama BTH Connect
appears in the list of Bluetooth
-capable terminal devices.
®
-capable
®
is
®
-capable
®
connection.
®
settings on your terminal
®
devices found.
®
• Select Hama BTH Connect and wait until
the earphones are listed as connected in the
Bluetooth
• If the connection was successful, you will hear
another acoustic signal and the LED (7) slowly
flashes blue.
Note – Bluetooth
Some terminal devices require a password in order
to connect to another Bluetooth
• If your terminal device requests a password for
connection to the earphones, enter 0000.
Note
• Once the connection has been established, a
voice says, "Connected".
• If the connection attempt takes longer than
300 seconds to complete, it is cancelled and
the LEDs go out. In this case, repeat the steps
listed previously under 5.1 Bluetooth
5.2. Automatic Bluetooth
successful pairing)
Note
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that your Bluetooth
terminal device is visible for other Bluetooth
devices.
• For more information, please refer to the
operating instructions of your terminal device.
• Switch on the earphones with the MF button (5).
The blue LED begins to flash and the earphones
automatically connect with the last terminal
device used.
Note
®
• Once the connection has been established, a
voice says, "Connected".
• If the connection attempt takes longer than
300 seconds to complete, it is cancelled and
the LEDs go out. In this case, repeat the steps
listed previously under 5.2.
• It may be necessary to change the settings
on your terminal device to enable it to
automatically connect to the earphones.
settings on your terminal device.
®
password
®
®
connection (after
®
device.
pairing.
®
-capable
®
is
®
-capable
®
®
3