Replacing The Remote Control Battery; Usage - easymaxx TS-21548 Mode D'emploi

Replacing the remote control battery

Before inserting the battery, check whether the contacts in the
remote control and on the battery are clean, and clean them if
necessary.
3. Push the battery compartment back into the remote control
as far as it will go. It must audibly and noticeably lock into
place.

Usage

PLEASE NOTE!
■ Only use the heater in wall sockets in a vertical position, not
horizontal ones (lying fl at).
■ The device is equipped with overheating protection, and in
case of overheating, the device switches itself off . In this
case, switch off the device, let it cool down and unplug it
from the socket. After approx. 10 – 15 minutes it is ready
for use again.
• The device can be operated either via the buttons
on the device or via the remote control.
• The default settings are: 25 °C, high speed (HH)
and 8-hour timer.
1. The battery compartment is
pull
2. Remove the used battery and
press
25
located on the narrow side of
the remote control. Pull out as
shown.
insert a new battery (3 V; type
CR2025). The positive terminal
must point upwards.
EN