EUFAB 30400 Manuel De L'opérateur page 3

Rotating flashing light
OVERVIEW
• Introduction • Proper use of the product • Specifications • Safety notes • Operation • Maintenance • Contact information
WARNING!
Please read the operating instructions carefully prior to use and observe all safety instructions!
Non-compliance can lead to personal injuries, damage to the device or your property!
Please retain the original packaging, the proof of purchase as well as these instructions for subsequent
reference! When passing on the product, please include these operating instructions as well.
Please check content of package for integrity and completeness prior to use!
1. INTRODUCTION
Thank you very much for choosing the rotating flashing light from EUFAB. The rotating flashing beacon sticks safely on the car roof
or on a metal surface by means of a rubber sucker and a magnet plate, connection to the cigarette lighter or standard vehicle socket
outlet. The H1 filament lamp is replaceable.
2. PROPER USE OF THE PRODUCT
As a signal for oversize and special vehicles
According to the German Regulations Authorising the Use of Vehicles for Road Traffic (StVZO), private people may not use this beacon
without special authorization.
3. SPECIFICATIONS
Designation: rotating flashing beacon
Operating voltage: 12 / 24 V
4. SAFETY NOTES
• Keep children away and do not let children to operate this appliance!
• Use this product only for the use intended purpose!
• Do not manipulate nor take the appliance apart!
• For your own safety, exclusively use the accessories or spare parts that are specified in the instructions or
recommended by the manufacturer!
• Note the statutory regulations during operation.
5. OPERATING MANUAL
Before commissioning, check the voltage of your vehicle socket outlet. The rotating beacon is delivered with a 12 V lamp. For
operation on a 24 V on-board power supply, the lamp must be replaced (24 V lamp included in scope of delivery). See section
6, Replacing the bulb.
Before you mount the rotating flashing beacon on your vehicle, ensure that the magnetic disk and the surface intended for it are clean
and flat. Fix the rotating flashing beacon by pressing it lightly. Stick the plug into the outlet of the cigarette lighter. To avoid damages
to painted surfaces, do not pull or shift the rotating flashing beacon horizontally. To detach the rotating flashing beacon, first release
the rubber sucker by pulling the tab upwards and then lifting the beacon from your vehicle.
6. MAINTENANCE
Clean the appliance with a dry, soft cloth after use. Store the rotating flashing beacon dry and protect the hood against scratches.
Changing the lamp:
• Hold the base with one hand and gently twist the cap with the other hand counterclockwise up to the limit stop.
• Lift off the hood upwards.
• Fold the holding wire away from the base of the lamp.
• Pull the lamp upwards and remove the connection cable.
• The installation of the new lamp takes place in the reverse sequence.
7. NOTES ON ENVIRONMENTAL PROTECTION
Electrical appliances may not be disposed of together with the normal household waste! Please dispose of this appliance
over the public/municipal collecting points. The materials can be recycled as specified by the mark. Through recycling,
material utilization or other forms of the reuse of old appliances, you make an important contribution to protect our
environment!
8.
CONTACT INFORMATION
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
Power rating: 55 W / 70 W
Connection cable: approx. 2.5 m to the cigarette lighter
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
Weight: 0.800 kg
3