REX RDTF24/7C Notice D'utilisation page 14

14
Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much con‐
densed water on the rear
wall of the refrigerator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not wrap‐
ped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
During the automatic de‐
frosting process, frost melts
on the rear plate.
Door was opened too fre‐
quently.
Door was not closed com‐
pletely.
Stored food was not wrap‐
ped.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
Solution
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet‐
ter.
Refer to "Operation" chap‐
ter.
Set a higher temperature.
Refer to "Operation" chap‐
ter.
Set a higher temperature.
Refer to "Operation" chap‐
ter.
This is correct. Dry the water
with a soft cloth.
Open the door only when
necessary.
Make sure the door is
closed completely.
Wrap food in suitable pack‐
aging before storing it in the
appliance.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.