dji RONIN-S Guide De L'utilisateur page 2

EN
Disclaimer and Warning
Congratulations on purchasing your new DJI OSMO TM product. The
information in this document affects your safety and your legal rights
and responsibilities. Read this entire document carefully to ensure
proper configuration before use. Failure to read and follow instructions
and warnings in this document may result in serious injury to yourself or
others, damage to your DJI OSMO product, or damage to other objects
in the vicinity. This document and all other collateral documents are
subject to change at the sole discretion of DJI OSMO.
By using this product, you hereby signify that you have read this
disclaimer and warning carefully and that you understand and agree
to abide by the terms and conditions herein. You agree that you are
solely responsible for your own conduct while using this product, and
for any consequences thereof. You agree to use this product only for
purposes that are proper and in accordance with all applicable laws,
rules, and regulations, and all terms, precautions, practices, policies
and guidelines DJI OSMO has made and may make available.
DJI OSMO accepts no liability for damage, injury or any legal
responsibility incurred directly or indirectly from the use of this product.
The user shall observe safe and lawful practices including, but not
limited to, those set forth in this document.
Notwithstanding above, your statutory rights under applicable national
legislation are not affected by this disclaimer.
OSMO is a trademark of SZ DJI OSMO TECHNOLOGY CO., LTD.
(abbreviated as "DJI OSMO") and its affiliated companies. Names of
products, brands, etc., appearing in this document are trademarks or
registered trademarks of their respective owner companies. This product
and document are copyrighted by DJI OSMO with all rights reserved. No
part of this product or document shall be reproduced in any form without
prior written consent of or authorization from DJI OSMO.
Introduction
Use the RONIN TM -S Universal Mount to install the Ronin-S to a carrier
with 1/4"-20 holes. With a Universal Mount, the Ronin-S can be mounted
on a car, a jib, or a cable cam system. Use the cable included to
connect one of the two independent DC-IN ports on the mount to a Dual
TB50 Battery Mount to power the Ronin-S. Other DJI approved cables
can also be used to connect to corresponding devices to supply power
to or communicate with the Ronin-S.
In the Box
Universal Mount × 1 Base Plate × 1 P-Tap Power Cable × 1
1