Candy DSI 730 Mode D'emploi page 9

Attention
This dishwasher is equipped with an anti-overflow safety device
which works even when power is switched off, and if the water
level is too high the supply will automatically be closed off.
Important
To ensure the correct operation of the anti-overflow safety
device, it is recommended not to move or to tilt the dishwasher
during operation.
If it is necessary to move or to tilt the dishwasher, first make
sure the washing cycle is finished and that no water is left in
the tank.
Selecting the programme and special functions
Use in conjunction with programme guide
To set the programme, turn the dial clockwise until the pointer
( ) indicates the symbol of the required programme on the
control panel. Then press the On/Off button. Ensure that the
water supply is turned on and the door is closed properly.
"70°C" button
This button is an option available on the UNIVERSAL
INTENSIVE 70°C and DAILY INTENSIVE 70°C programmes
which will increase the temperature of the water of washing
from 50°C to 70°C.
Extra rinse button
Extra rinse for very dirty washing.
32' button
This button reduces the final heating of the water during the
last rinse. This activates a natural drying process, as with a
normal draining board, simply by leaving the door ajar at the
end of the cycle to enable the natural circulation of air. The
"32' button" button permits an energy saving of more than
20% and shortens the cycle.
Recommended for evening washes when the dishes are not
required perfectly dry, immediately, straight after washing.
This button when used in conjunction with the "Delicate"
programme provides a Super-Rapid wash programme (4/6
place settings) in around 30 minutes.
IMPORTANT:
When this button is selected, the programme finishes at
the " " position on the programme dial.
The cycle ends
When the program handle reaches the
ends.
Push the On/Off button to cut power to the dishwasher and
then only open the door.
S
symbol, the cycle
16
Watercontrol-system
The water-stop device protects against water damages caused by
leaks on the fill hose which could develop due to natural ageing
of the hose.
In the water-stop system the leaking water fills the corrugated
hose and activates a stop valve which cuts off the water supply to
the machine.
This fault is shown by a red sector on the window «A».
Would this occur, please refer to your Service Agent.
If the hose is not long enough for correct connection, it must be
replaced with a longer one. The hose can be obtained from your
Service Agent.
Safety antitwist device
(press and twist to
remove the washer)
A
Red button blocked
valve indicator
17