Honeywell HQ09 Série Mode D'emploi page 22

INSTALLATION
It is important that the installation instructions below are followed for successful installation of this
Honeywell Portable Local Air Conditioner. Please call Customer Support if you have any difficulties or
queries regarding these installation procedures.
1
Installation Kit:
1. Window Bracket Kit
2. Window Bracket Panel Adapter (1 Piece)
3. Plastic Pin
Installation Steps:
1. Install the exhaust hose with window bracket adapter and hose connector on both sides. Ensure proper
fit on both ends.
2. Adjust the window bracket as per width or height of your window and insert the plastic pins to fix at the
desired position. There is a hole where the exhaust hose will be inserted later. Make sure this hole is not
blocked.
2
x1
5
(1 Set)
(2 Pieces)
26.6", 36.2" to 52"
(67.5cm, 92cm to 132cm)
3
x1 x2
6
x1
4. Hose Connector
5. Exhaust Hose
6. Drain Tube (refer to Continuous
Draining for Dehumidifier Mode)
Plastic Pin
Hole for Window Bracket
Panel Adapter & Exhaust Hose
EN 3
4
x1
x1
(1 Piece)
(1 Piece)
(1 Piece)