ADURO P1 Série Mode D'emploi page 70

•
Clean the stove properly
•
Remove any remaining pellets from the pellet container
•
Completely empty the auger for pellets
•
Unplug the power cable
9.2 Daily, weekly and monthly cleaning/maintenance
Daily
Clean the brazier (3) thoroughly to avoid residues of ashes and partly
burnt pellets.
We recommend emptying the ash tray (4) and to vacuum clean the
combustion chamber and the door (around the gaskets) on a daily
basis.
Upon every ignition, the brazier must be checked for ashes and
unburnt/partly burnt pellets.
Weekly
Once a week, the baffle plate (1) and the back plate (2) inside the
combustion chamber should be removed in order to enable the
cleaning of the covered parts. Use an ash vacuum cleaner and, if
necessary, a soft brush or dry cloth.
Monthly
Every month, the box below the combustion chamber needs to be cleaned with an ash vacuum cleaner.
Unscrew the 4 bolts to remove the cover plate (5). After cleaning, make sure the cover plate closes tightly.
The frequency of cleaning periods depends on the combustion. The better the combustion, the less residues
will settle in the combustion chamber, the air channels and flue pipes.
9.3 Surface maintenance
The stove's surface is treated with a powder coat paint. When cleaning the stove, avoid strong detergents
and abrasives, and all products containing solvents, alcohols, acids, or any solvent.
Painted and plastic parts can be cleaned with a slightly damp cloth and use only a mild detergent diluted with
water.
9.4 Annual service visit
The annual service visit must be conducted by an authorised service partner. Contact your retailer for further
information.
9.5 Spare parts and unauthorized alterations
You may only use original spare parts for your stove. All forms of unauthorized alterations to the stove are
strictly forbidden, as the stove will no longer comply with the approved specifications. At
www.aduroshop.com you can buy original spare parts for your stove.
70