Gas Connection Procedure; Electrical Connection (Only For E Version) - CAN FC Série Manuel D'instructions

Masquer les pouces Voir aussi pour FC Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GAS HOB UNITS WITH GLASS RECESSED LID ▪

GAS CONNECTION PROCEDURE

The appliance is supplied with a gas train with a
smooth end section and free for at least 30 mm, fit
to house suitable press fittings. Proceed as follows
to set up the gas connection:
step
1
Connect the Ø 8 mm pipe to the clamp fitting of
the gas distribution network.
ATTENTION!
During the installation and connection
operations, the gas supply pipe of the
appliance must not be subject to twisting,
traction or any other mechanical stress
which could jeopardise tightness and
strength.
After connecting the equipment to the gas mains, check the fittings
to make sure they are sealed by using a solution of water and soap or a testing device for pressure leak
tests. Gas installation technicians usually have them.
ATTENTION!
It is absolutely prohibited to use naked flames to check tightness and to put the device into
service! If the test is satisfactory, light all the burners to make sure that the flame is regular
and stable.

ELECTRICAL CONNECTION (only for E version)

E versions are equipped with a low voltage spark generator (12 V DC) to light the burners, generally installed
on the metal bracket at the bottom of the hob unit. To connect the generator to the local power mains,
proceed as follows:
step
1
Connect the free end of the black conductor (-)
to the negative pole of the terminals of the mains
or of a battery.
2
Connect the free end of the black conductor (+)
to the positive pole of the terminals of the mains
or of a battery.
ATTENTION!
Any type of connection of the appliance
to a power mains other than 12V and in
direct current (DC) is strictly prohibited.
Any other connection can pose a severe
danger for the user of the appliance and
cause irreversible damage to the device
itself.
98
action
action
FC series
EQUIPMENT REQUIRED
Please note: the fittings are not supplied with the product.
They are solely supplied and connected by the installer.
4
4
3
4
2
5
5
5
6
1
-
+
12 V DC
1 Power cable positive pole
2 Power cable negative pole
3 Connection cable generator
button
4 Glow plugs fast-on housing
5 Glow plugs fast-on
connectors
6 12V DC (+ -) power supply
fast-on connectors

Publicité

Table des Matières
loading

Table des Matières